Danby Designer DWC040A3BSSDD Manual Del Propietário página 5

INSTALLATION INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the two screws securing the hinge cover
and remove the hinge cover. See fi gure A.
2. Remove the three screws securing the upper
hinge and remove the upper hinge. Remove the
door from the chassis. See fi gure B.
3. Remove the hole plugs from the left side of the
chassis and place them in the screw holes on the
right side of the chassis. See fi gure C.
4. Remove the solid foot from the left side of the
chassis and remove the three screws securing
the lower hinge on the right side of the chassis.
Install the solid foot on the right side of the
chassis and the lower hinge on the left side of
the chassis. See fi gure D.
5. Before reinstalling the door, remove the two
screws securing the actuator to the bottom of
the door. Flip the door 180° from its original
position and use two screws to reinstall the
actuator. Screw holes cane be found by gently
pulling back the rubber gasket. See fi gure E.
6. Install the door on the lower hinge and then
install the upper hinge on the left side of the
chassis. Before tightening the screws in the
upper hinge, ensure that the top of the door is
properly aligned with the top of the cabinet and
that the rubber gasket makes a good seal with
the cabinet all the way around. Use two screws
to install the hinge cover. See fi gure F.
1. Rubber Screw Covers
2. Screws
3. Hinge Cover
4. Upper Hinge
5. Hole Plugs
6. Lower Hinge
7. Solid Foot
8. Actuator
A
B
C
D
E
F
4
1
2
3
2
4
5
6
2
7
2
8