Publicidad
Idiomas disponibles
Idiomas disponibles
Page 8
SB-2-543-F
trouBleSHootInG (continued)
conDItIon
Fluid dripping or leaking from
bottom of cup
runs and sags
thin, sandy coarse finish drying
before it flows out
thick, dimpled finish "orange peel"
All manuals and user guides at all-guides.com
cauSe
Cup gasket worn or missing below cup.
Cup threads dirty.
Too much material flow.
Material too thin.
Gun tilted on an angle, or gun
motion too slow.
Gun too far from surface.
Too much air pressure.
Improper thinner being used.
Gun too close to surface.
Air pressure too low.
Improper thinner being used.
Material not properly mixed.
Surface rough, oily, dirty.
correctIon
Tighten.
Replace cup gasket.
Clean.
Adjust gun or reduce fluid flow.
Mix properly or apply light coats.
Hold gun at right angle to work and
adapt to proper gun technique.
Check distance. Normally approx. 8".
Reduce air pressure and check spray pattern.
Follow paint manufacturer's mixing instrs.
Check distance. Normally approx. 8".
Too much material coarsely atomized.
Increase air pressure or reduce fluid flow.
Follow paint manufacturer's mixing instrs.
Properly clean and prepare.
Publicidad
