Diamond AD1B/H-R2 Instrucciones De Servicio página 11

ENGLISH
Press to confirm your selection;
 Press the
the value of the setting, and press the
 Follow the above instructions to edit any
of the other parameters.
Viewing the probes
GB
Quick consultation of the probes only when the
card is in STANDBY.
Press and hold the
then press the
to view the probes in this order:

Evaporator probe (the freezing icon lights
up)
and buttons to edit
button to save the new value;
button for 3 seconds:
button again once at a time
To exit programming mode, press and hold both
the and buttons for at least 5 seconds
or wait one minute without pressing any of the
buttons.

Condenser probe (the blast chilling icon
lights up)

Cell probe (the preserving icon lights up)

Needle probe (the needle icon lights up)
Press the button or wait 70 seconds to exit.
4