Glacier bay 65480W-6101 703445 Guía De Uso Y Mantenimiento página 5

Installation (continued)
3
Installing the drain body
□
Apply silicone sealant (not included) under the
drain ange (F) and place the drain ange (F)
into the drain hole of the sink.
□
From underneath the sink, screw the drain
body (I) onto the drain ange (F). Ensure that
the opening (1) for the ball rod on the drain
body (I) faces towards the rear of the sink.
□
Tighten the rubber washer (G) and lock nut (H)
on the drain body (I). Do not overtighten.
G
H
F
1
1
I
4
Installing the stopper and ball
rod
NOTE: In shallow cabinet installations, the ball rod (K) may
need to be shortened. Use a hack saw to cut the end of the
rod, away from the ball, to the desired length.
□
Insert the stopper (E) into the drain hole in the sink.
□
Remove the lift rod strap (N) and spring clip (L)
from the ball rod (K).
□
Remove the ball nut (J). Insert the ball rod (K) into
the drain body (I) and through the hole of the
stopper (E). See Insert 1.
□
For easier removal and cleaning, rotate the
stopper (E) 90 degrees so that the ball rod (K)
does not go through the hole in the stopper (E).
See Insert 2.
□
Secure the ball nut (J) against the hole in the drain
body (I) and tighten the ball nut (J) onto the
threaded end. Do not overtighten.
Insert 2
I
5
Please contact 1-855-HD-GLACIER for further assistance.
E
1
I
Insert 1
N
K
J
L
HOMEDEPOT.COM