Publicidad
Idiomas disponibles
Idiomas disponibles
IM WFCH2 V40 P :WFCH1_inst 8/13/09 1:47 PM Page 18
STEP 3
-Optional Direct Connect
Mount the System Head
1
Choose an easy-to-access area under the sink to mount the Filter System.
NOTE: To allow adequate space for filter changes, allow a minimum clearance of 4-6" below the QuickTwist
must be mounted in a vertical position.
NOTE: Mount the Filter System to a solid cabinet wall or wall. If a solid surface is not available, use hollow-wall anchor bolts or toggle
bolts (not included) to secure to the wall.
2
Remove the cap from the top of the System Head
provided on the back of this booklet, mark the holes for the Mounting Screws
3
Using a 1/8" drill bit, drill two pilot holes for the Mounting Screws. Insert Mounting Screws into the wall with a Phillips screwdriver,
leaving approximately 3/8" of each Mounting Screw exposed.
4
Hang the System Head on the eyes of the bracket and replace the System Head cap.
X
X
STEP 4
-Optional Direct Connect
Install 1/4" Plastic Tubing for Water Supply Line from
Kitchen Faucet dapter to System Head Inlet
1
Determine the length of 1/4" Plastic Tubing
H
dapter
. Make sure to allow enough Plastic Tubing to prevent kinking in the line.
2
Cut the 1/4" Plastic Tubing squarely on both ends.
3
Wet one end of the 1/4" Plastic Tubing with water and push it into the Kitchen Faucet dapter approximately 5/8" until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
4
Wet the other end of the 1/4" Plastic Tubing with water and push it into the System Head Inlet approximately 5/8" until it stops.
NOTE: The 1/4" Plastic Tubing does not need to be disconnected for general routine maintenance and filter replacement. However,
Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to the Filter System and press in the grey collar
around the fitting while pulling the Plastic Tubing out with the other hand.
WFCH2 Series
. Using the Built-in Bracket on the back of the System Head or the template
C
on the wall surface.
L
that will be necessary to connect the System Head Inlet to the Kitchen Faucet
™
Filter. The Filter System
X
X
17
3
2
INLET
4-6"
3
4
HOT W TER
COLD W TER
V LVE
V LVE
1/4" PL STIC TUBING
INLET
4
OUTLET
5/8"
3
OUTLET
WFQT130005
V4.0
Publicidad
