DuPont WFPF3800 Instrucciones De Instalación página 19

IM WFCH2 V40 P :WFCH1_inst 8/13/09 1:47 PM Page 19
STEP 5
-Optional Direct Connect
Install 1/4" Plastic Tubing for Water Supply Line from
System Head Outlet to Faucet
1
Determine the length of 1/4" Plastic Tubing
Stem. Make sure to allow enough Plastic Tubing to prevent kinking in the line.
2
Cut the 1/4" Plastic Tubing squarely on both ends.
3
Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Outlet until it stops.
4
Gently slide the plastic Compression Nut down
that the Ferrule is in the proper position with the larger opening on the bottom (going into the nut). Place the plastic Insert
the end of the 1/4" Plastic Tubing.
Firmly push the 1/4" Plastic Tubing into the end of the threaded Faucet Stem. Hand-tighten the plastic Compression Nut onto the
threads. Tighten with an adjustable wrench approximately 1/2 turn.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting. Do not over tighten the Compression Nut.
STEP 6
-Optional Direct Connect
Install the QuickTwist
1 B
Hold the QuickTwist ™ Filter with the label facing to the left slightly. The two nozzles on top of the QuickTwist
toward the back of the QuickTwist
1
out to each side. See Figure 6
2
Lift the QuickTwist ™ Filter straight up into the System Head
on top of the QuickTwist ™ Filter are fully engaged into the System Head.
3
Turn the QuickTwist ™ Filter counter-clockwise until it stops.
WFCH2 Series
L
that will be necessary to connect the System Head Outlet to the threaded Faucet
G
(thread side up) over the tubing. Follow with the plastic Ferrule
™ Filter
™ Filter. If holding properly, the two extended flanges on top of the QuickTwist
at right.
until the two nozzles seat into the ports and the two extended flanges
5
FILTERED W TER
X
J
, making sure
X
I
into
6
™ Filter should be
™ Filter should be
18
X
1/4" PL STIC TUBING
INLET OUTLET
3
F UCET FOR
I
J
G
4
1
2
B
3
X
V4.0