Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
Before starting the tool and during operation, keep
•
your hand and face away from the application tool.
Do not apply excessive load to the tool which may
•
cause a motor lock and stop the tool.
Cutting, sawing and scraping
012801
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
Forcing or excessive pressure on the tool may
•
reduce efficiency.
Before cutting operation, it is recommended to
•
preset the orbital stroke rate 4 - 6.
Sanding
WARNING:
Do not reuse a sanding paper used for sanding
•
metal to sand wood.
Do not use a worn sanding paper or sanding paper
•
without grit.
012769
Apply a sanding paper on the workpiece.
NOTE:
Using
a
test
•
recommendable to determine a correct orbital
stroke rate suitable for your work.
Use a sanding paper with the same grit until
•
sanding the whole workpiece is completed.
Replacing a sanding paper with different grit
material
sample
to
sanding paper may not get a fine finish.
Dust extraction attachment (optional accessory)
2
1. Nozzle band
2. Dust nozzle
3. Dust nozzle
4. Dust attachment
5. Felt ring
6. Pad
7. Application tool installation bolt
8. Holes in the tool
9. Protrusions on the nozzle band
012778
Install dust nozzles and dust attachment.
•
Install the nozzle band on the tool so that its
•
protrusions fit in the holes in the tool to secure it.
Put the felt ring and the sanding pad on the dust
•
attachment and then secure them with the
application tool installation bolt.
try
is
012800
8
1
8
3
4
9
5
6
7
Publicidad
