Publicidad
Idiomas disponibles
Idiomas disponibles
1 4 | Quick Start Guide
Function
Output Switch
Test
Pre-Trigger
Setup
Print Data
Print Header
Program
Mode
Quick Test
575610 Rev B | 03.2016
Menu
On Demand Tests
System Setup
Main, Diagnostic,
Datastream, Diag-
nostic Codes,
Special Tests, On
Demand Tests
System Setup
System Setup
System Setup
Description
This function tests output devices
such as actuators, solenoids, and
relays controlled by the powertrain
computer module. This test will
toggle the devices ON / OFF and a
voltmeter can be used to verify the
signal is actually reaching the
output device. This function only
applies to Ford OBD I vehicles.
This function is used to configure
how many Pre-Trigger frames are
stored prior to beginning a record-
ing.
Prints diagnostic information
stored in the Scan Tool. (Refer to
Users Manual)
Allows the user to turn off the Scan
Tool printing the currently-selected
vehicle prior to the retrieved vehi-
cle data when selecting items from
the Print Data menu.
Used for updating the Scan Tool.
Allows the user to turn off the Scan
Tool performing Read Codes and
I/M Monitors after vehicle selection
when the Scan Tool is connected
to the vehicle.
Bosch Automotive Service Solutions Inc.
English
Publicidad
