Ryobi PBLHM101 Manual Del Operador página 7

APPLICATIONS
You may use this tool for the purposes listed below:
PBLHM101
Hammer drilling in concrete, brick, or other masonry.
Drilling in all types of wood products (lumber, plywood,
paneling, composition board, and hard board), ceramics,
plastics, fiberglass, laminates, and metals; driving screws
into wood and drywall with screwdriver bits
PBLID02
Driving long deck screws, driving carriage bolts into deck
posts; driving Tapcon screws into block walls and concrete;
®
driving screws into metal studs
CAUTION:
These tools are not intended to be used for mixing
concrete, drywall, grout or other similar types of viscous
mixtures. Failure to obey this caution could cause poor
performance, possible injury, and will void your warranty.
INSTALLING/REMOVING BELT HOOK OR BIT
HOLDER (NOT INCLUDED)
See Figure 2, page 12 (PBLHM101).
See Figure 1, page 13 (PBLID02).
The belt hook and bit holder are interchangeable. They may
be installed on either side of the base.
 Align hole in belt hook or bit holder with hole in tool's
base.
 Install screw to secure belt hook or bit holder in place.
 To uninstall, remove screw and then belt hook or bit
holder.
VARIABLE SPEED SWITCH TRIGGER
See Figure 3, page 12 (PBLHM101).
See Figure 2, page 13 (PBLID02).
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the collet or chuck
to come to a complete stop.
OPERATION
PBLHM101 HAMMER DRILL / PBLID02 IMPACT DRIVER
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
NOTE: Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
DIRECTION OF ROTATION SELECTOR
(FORWARD / REVERSE / CENTER LOCK)
See Figure 3, page 12 (PBLHM101).
See Figure 2, page 13 (PBLID02).
Set the direction of rotation selector in the OFF (center lock)
position to lock the switch trigger and help prevent accidental
starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward operation. Position the selector to
the right of the switch trigger to reverse the direction.
NOTE: The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
NOTICE:
To prevent gear damage, always allow the collet to
come to a complete stop before changing the direction
of rotation.
WARNING:
Battery tools are always in operating condition. Lock the
switch when not in use or carrying at your side, when
installing or removing the battery pack, and when install-
ing or removing bits.
INSTALLING / REMOVING BATTERY PACK
See Figure 4, page 12 (PBLHM101).
See Figure 3, page 13 (PBLID02).
 Lock the switch trigger.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery
pack snap in place and battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
7 - English