Futurelight PHW-260 Manual Del Usuario página 49

Lamp
- Main menu 1
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DN] to select "LAMP".
- Lamp on/off
With this function you can switch the lamp on or off via the Control Board.
• Select "OPEN" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Lamp on/off via power switch
With this function you can switch the lamp on or off via the power switch.
• Select "LAAU" by pressing [UP] or [DN].
• Press [ENTER], the display shows"ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Lamp on/off via external controller
With this function you can switch the lamp on or off via an external controller.
• Select "ONLI" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Delay lamp on
With this function you can delay the lamp ignition.
• Select "DELA" by pressing [UP] or [DN].
• Press [MODE/ENTER] to confirm; the display shows "D-00". In this setting, the lamp will be ignited
immediately.
• Press [UP] to select the desired delay between "00" and "59" minutes. If you select "D-03" the lamp
will be ignited after 3 minutes.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 2
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DN] to select "SET".
49/108 51838705_V_1_1.DOC