Glacier bay KHG48D Guía De Uso Y Cuidado

TOOLS REQUIRED
Claw hammer Safety goggles
Power drill
Measuring tape
Caulk/sealant Keyhole saw
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make
sure all parts are present. Compare
parts with the Hardware Included list.
If any part is missing or damaged, do
not attempt to install the product.
□ Determine the desired mounting location,
and mark the wall where the unit will be
installed.
NOTE: For secure installation, the
unit must be mounted to at least one
wall stud.
4
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with
washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate
locations and insert toggle bolts with washers (not included).
□ For concrete wall installation, drill 1/4 in. holes at the
appropriate locations and insert #12 wall anchors, followed
by #12 x 3 in. screws (not included).
5
INSTALLING THE HARDWARE
□ Attach the handle (AA) and knobs (BB)
to the door on the vanity with short
screws (CC) and to the drawers on the
vanity with long screws (DD).
Phillips screwdriver
Wall hardware
Level
2
CUTTING THE OPENING FOR
PLUMBING FIXTURES
NOTE: This step applies to vanity
cabinets with full back panels only.
□ Locate and mark plumbing on the back panel.
□ Drill a pilot hole through the back panel.
□ Use a keyhole saw to cut an opening for the
plumbing fixtures.
AA
BB
Use and Care Guide
HARDWARE INCLUDED
AA - Handle BB - Knob
KHG48D x 7 KHW48D x 7
3
CC
DD
Please contact 1-888-774-8062 for further assistance.
Item #0000 000 000
Item #0000 000 000
Item #0000 000 000
Item #0000 000 000
Item #0000 000 000
Model #KHW48D
Model #KHG48D
Vanity Combo
CC - Short DD - Long
Screw Screw
KHG48D x 2 KHG48D x 12
KHW48D x 1 KHW48D x 6
POSITIONING THE
CABINET
□ Move the cabinet into
place, and use wood
shims to level the
cabinet against the wall.
CC
DD
BB
HOMEDEPOT.COM