Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL CONNECTIONS
REMEMBER -Turn off the power! NOTE - Control must be installed within
30 feet of fan.
WARNINGS: Check to see that all connections are tight, including ground,
and that no bare wire is visible at the wire nuts, except for the ground wire.
CAUTION: To reduce the risk of electric shock, this fan must be installed with
an isolating wall control/switch.
1.
Insert the receiver into the ceiling mounting bracket with the flat side of
the receiver facing the ceiling. (Fig. 1) For best performance, make sure
the Black Antenna and WIFI Antenna, on the end of the receiver, remains
extended and not tangled with any of the electrical wires.
2. Make wire connections from the fan to the receiver unit. For this
step use the bundle of 5 wires on the receiver. (Fig. 2)
Connect the YELLOW fan wire to the YELLOW receiver wire.
Connect the GRAY fan wire to the GRAY receiver wire.
Connect the RED fan neutral wire to the RED receiver neutral wire.
Connect the WHITE neutral light kit lead from the fan to WHITE receiver
lead marked " For Light".
Connect the BLUE light kit lead from the fan to BLUE receiver lead
marked "For Light".
Wire colors out of the fan are blue/white for the light kit. Light kit leads
from the controller/receiver are blue/white.
3. Connect the wiring from the ceiling to the receiver unit. (Use the 2 wire
bundle on the receiver.) Secure with supplied wire nuts.
Connect the BLACK building supply wire to the BLACK receiver wire.
Connect the WHITE receiver neutral wire to the WHITE building neutral
wire.
Connect the COPPER building ground wire to the 4 YELLOW/GREEN
ground wires from the fan and receiver.
Receiver
Fig. 1
08
|
hinkley.com
BLK (AC IN)
WH (AC IN)
BLUE (For light)
WHITE
(For light)
Receiver
YELLOW
YELLOW
BLUE
Hanger
WHITE
bracket
Fig. 2
GROUND
Outlet box
Ceiling
GRAY
RED
RED
GRAY
Fan
Publicidad
