Pioneer PDP-S60 Manual De Instrucciones página 4

English
2. Screw an supplied screw into the
speaker mounting hole (lower of the
two) at the top, rear of the display.
Do not tighten it all the way yet. Leave it loose, with
about 5 mm left to tighten.
Speaker
Mounting
Hole
Top of Display
Leave a space of about 5 mm
3. Hang the speaker mounting fitting
on the screw you installed at the top
by passing the wide part over it and
lowering into the slot; screw in the
lower screw temporarily.
After passing the wide part of the hole of the speaker
mounting fitting (top) over the screw, lower the
speaker onto it.
After passing the
wide part of the hole
over the screw, lower
the speaker.
Tighten with the
provided screw the
bottom speaker
mounting fitting to the
display temporarily
(one place bottom).
4
Top, rear of
Display
5 mm
4. Adjust the position of the speaker
and then tighten the upper screw
firmly.
5. Tighten the screw, thus fixing the
speakers to the display.
6. Pass the supplied speaker cable
between the speaker and the plasma
television (below the speaker
mounting fitting) from below.
7. Connect the speaker cables to the
speaker (see next page).
8. Insert the cable in the groove on the
speaker.
Speaker Cable
9. Connect the other end of the speaker
cables to the rear of plasma
television (see next page).
Speaker Terminal
Insertion in
groove