Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO OPERATE THE MACHINE
WARNING: Water solutions or cleaning materials used
with this type of machine can leave wet areas
on the fl oor surface. These areas can cause a
dangerous condition for the operator or other
persons. Always put CAUTION signs near the
area you are cleaning.
WARNING: Machines can ignite fl ammable materials and
vapors. Do not use with or near fl ammables
such as gasoline, grain dust, solvents and
thinners. Only use a cleaning concentration
recommended by the chemical manufacturer.
WARNING: Clarke recommends a maximum water tem-
perature of 120
Operating The Machine
NOTE: Put the machine in the lowest traverse speed setting. Use the
machine in an area that has no furniture or objects until you can do the
following:
1.
Move the machine in a straight direction, forward and backward.
2.
Stop the machine safely.
3.
Turn the machine both left and right and return to a straight direc-
tion.
To move the machine, follow this procedure:
1.
Release the parking brake (if equipped with machine).
2.
Turn the key switch to the "ON" position
3.
Raise the brush.
4.
Raise the squeegee.
5.
When either the left or right forward palm buttons (fi gure 20, item
A) are pushed in, the machine will go forward.
6.
Control the speed of traverse by using the traverse speed control
knob (fi gure 20, item C).
7.
To stop, release the forward palm buttons.
8.
To reverse the machine, push in the white reverse switch (fi gure
20 item B) and either the right or left forward palm buttons (fi gure
20 item A) at the same time.
9.
To stop, release the forward palm buttons.
10.
To turn the machine, push the rear of the machine to the side.
11.
When you stop the machine, turn the key switch "OFF", remove
the key and set the parking brake (if equipped).
Clarke
®
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
F (49
C).
o
o
ENGLISH
B
Figure 20
®
EN
A
A
C
FORM NO. 71483A - 19 -
Publicidad
