Maruyama MCV3900 Manual De Usuario página 23

WARNING
PETROL AND FUEL ARE EXTREMELY
FLAMMABLE. IF SPILLED OR
IGNITION SOURCE, IT CAN CAUSE
FIRE AND SERIOUS INJURY OR
PROPERTY DAMAGE. EXTREME
CAUTION IS REQUIRED, WHEN
HANDLING PETROL OR FUEL.
FUEL
1. Use an appropriate type fuel container.
2. Do not smoke or bring flame or sparks near fuel
supplies.
3. The fuel tank may be under pressure. Always loosen
the fuel cap and wait for pressure to be equalized before
removing the cap.
4. When the fuel tank cap (1) or oil tank cap (2) is difficult
to remove by hand, put the attached socket wrench
into the groove of the cap and turn it anticlockwise.
5. Fill the fuel tank outdoors over bare ground and install
the fuel cap securely. Do not pour fuel indoors.
6. Wipe any spilled fuel off the unit.
7. Never refuel while the engine is still hot. or refuel a
running engine.
8. Do not store the unit with fuel in its tank, because a
fuel leak could start a fire.
9. After refuelling tighten fuel cap firmly (1) and check for
leakage. In case of fuel leakage repair before starting
operation since there is a danger of fire.
1
2
NOTE
Do not use excessive force when tightening the tank
cap with the socket wrench as the tank cap is made
of plastic. If there is any damage to the tank cap do
not start the engine.
Ask your MARUYAMA dealer for a replacement cap.
STARTING THE ENGINE
1. Move the chain saw at least 3 m from the fuelling point
before starting the engine.
2. Do not allow other persons to be near the chain saw
when you are starting or cutting with the chain saw.
3. Keep bystanders and animals out of the work area. Do
not let anyone hold wood for you to cut.
4. Do not start cutting until you have a clear work area,
secure footing, and a planned retreat path from the
falling tree.
5. Before you start the engine, make sure that the saw
chain is not contacting anything.
6. Keep the handles dry, clean, and free of oil or fuel
mixture.
7. Operate the chain saw only in welI-ventilated areas.
Exhaust gas, oil mist (from chain saw lubrication) or
saw dust saw is harmful to health.
8. When starting the chain saw place the unit on a flat
ground and hold the front handle with left hand and
hold firmly the rear end of rear handle with right knee
and pull starter handle with your right hand.
DO NOT DROP START THE CHAIN
SAW, DROP STARTING THE CHAIN
SAW IN AN INSECURE POSITION
AND CAN RESULT IN INJURY. START
THE CHAIN SAW IN THE CORRECT
MANNER.
KICKBACK SAFETY PRECAUTIONS
1. Tip contact in some cases may cause a Iightning-fast
reverse reaction, kicking the guide bar up and back
toward the operator (this is called a rotational kickback).
2. Pinching the saw chain along the top of the guide bar
may push the guide bar rapidly back toward the operator
(this is called a linear kickback).
3. Either of these reactions may cause you to lose control
of the saw and come in contact with the moving chain,
4.
which could result in serious personal injury.
4. With a basic understanding of kickback, you can redu-
ce or eliminate the element of surprise. Sudden surprise
contributes to accidents. Understand that rotational
kickback is preventable by keeping an unshielded bar
nose from touching an object or the ground.
ENGLISH
WARNING
GB
23