Publicidad
Enlaces rápidos
U P
C
®
®
ASME A112.18.1 / CSA B125.1
ASME A112.18.2 / CSA B125.2
NSF-61
ICC/ANSI A117.1
Model/Modelo/Modèle
578-DST
Series/Series/Seria
Write purchased model number here.
Escriba aquí el número del modelo comprado.
Inscrivez le numéro de modèle ici.
For easy installation of your Delta
faucet you will need:
• To READ ALL the instructions completely
before beginning.
• To READ ALL warnings, care, and maintenance
information.
Para instalación fácil de su llave Delta
usted necesitará:
• LEER TODAS las instrucciones completamente
antes de empezar.
• LEER TODOS los avisos, cuidados, e
información de mantenimiento.
Pour installer votre robinet Delta
facilement, vous devez:
• LIRE TOUTES les instructions avant de débuter;
• LIRE TOUS les avertissements ainsi que toutes
les instructions de nettoyage et d'entretien;
SINGLE HANDLE LAVATORY
54750
CENTERSET FAUCETS
LLAVES MONOCONTROL DE MONTURA
DE CENTRO PARA LAVAMANOS
ROBINETS À ENTRAXE COURT À
UNE POIGNÉE
You may need/Usted puede necesitar/
Articles dont vous pouvez avoir besoin:
1/8"
54750
1
T E FLO N
T E FLO N
3/15/10
Rev. B
Publicidad
Manuales relacionados para Delta 578-DST
Resumen de contenidos para Delta 578-DST
- Página 1 T E FLO N before beginning. • To READ ALL warnings, care, and maintenance information. 1/8" Para instalación fácil de su llave Delta usted necesitará: • LEER TODAS las instrucciones completamente antes de empezar. • LEER TODOS los avisos, cuidados, e información de mantenimiento.
- Página 2 MAKE ANY OTHER WARRANTY OF ANY KIND, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY. Delta will replace, FREE OF CHARGE, during the warranty period, any part or finish that proves defective in material and/or workmanship under normal installation, use & service. Replacement This warranty excludes all industrial, commercial &...
- Página 3 For Three Hole Mount For Single Hole Mount Para Las Instalaciones De Tres Agujeros Para Las Instalaciones De Un Agujero Montage Sur Trois Trous Montage sur un trou For three hole mount: For single hole mount: Slide escutcheon (1) and 3 hole gasket (2) up over tubes and Slide single hole gasket (1) up over tubes and mounting stud.
- Página 4 Faucet fittings (1) are 3/8" compression, with allows a leak-free joint to be created. Delta is not careful not to cut the tube too short. ends colored red for hot and blue for cold. Loop...
- Página 5 Incorrect Installation Correct method Instalación Incorrecta Método Correcto Installation Incorrecte Bonne méthode Do not install sleeve Ensure cut is straight. upside down. No instale la manga Asegúrese que el Custom Fit Connections - Plastic Sleeve Installation Instructions boca abajo. corte esté recto. 1.
- Página 6 Pop-Up with Metal Flange and Plastic Tail Piece (Follow the instructions for the type of pop-up included with your model.) With pivot (1) facing toward faucet, pull Remove stopper (1), brass nut & washer (2), Remove pivot nut (1). Install horizontal rod pop-up straight down into drain hole and black gasket (3) and tail piece (4).
- Página 7 Step 3b Metal Pop-Up (Follow the instructions for the type of pop-up included with your model.) Remove stopper (1) and flange (2). Step 3c Apply silicone to underside of flange (1). Insert Remove pivot nut (1). Install horizontal body (2) into sink. Screw flange (1) into body (2). rod (2) and stopper (3) as removable Screw nut (1) all the way down.
- Página 8 Remove aerator (1) using supplied wrench (2) and turn faucet Check all connections at arrows for leaks. Retighten if necessary, handle (3) to the full on mixed position. Turn on hot and but do not overtighten. cold water supplies (4) and flush water lines for one minute. Important: This flushes away any debris that could cause damage to internal parts.
- Página 9 Setting The Handle Limit Stop (Optional) this handle limit stop will not always prevent scalding because it This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range does not compensate for incoming pressure or sudden water temperature changes.
- Página 10 Maintenance Cleaning and Care If faucet exhibits very low flow: Care should be given to the cleaning of this reinstalling parts, make sure bonnet nut (4) is A. Remove and clean aerator (1) with supplied tightened securely with a wrench.* product.
- Página 11 RP54973▲ RP40650 Handle, Red/Blue Button & Set Screw Set Screw Manija, Botón Rojo/Azul y Tornillo Tornillo de Ajuste de Ajuste Vis de calage Manette, Bouton Rouge/Bleu et Vis RP54974 de Calage Red/Blue Button RP54972▲ Botón–Rojo/Azul Bouton–Rouge/Bleu Casquillo Embase RP54975 RP54976 O-Ring Bonnet Anillo O...
- Página 12 RP38958▲ Pop-Up Assembly Less Lift Rod Ensamble del Desagüe Automático Menos la Barra de Alzar Renvoi Mécanique Sans la Tige de Manoeuvre RP5648 ▲ Stopper Tapón RP12516 Bonde Strap & Screw Barra Chata y Tornillo Feuillard et Vis Metal Flange Brida de Metal Collerette en métal RP6142...