Publicidad
Idiomas disponibles
Idiomas disponibles
press for low speed and then each press on this button
repeats the high/low speed cycle alternatively.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the long nozzle
014603
To install the long nozzle, push in onto the blower outlet
of the tool all the way.
1
014604
To remove the long nozzle, press its both buttons and
with the buttons being pressed pull it out.
Installing the shoulder strap
014605
Pull the hanger out of the tool.
Hook the shoulder strap onto the hanger of the tool.
Before use, adjust the length of strap so that it is easy to
work with it.
1. Hook
1
2. Button
3. Long nozzle
2
3
1. Button
1
1. Hanger
1
OPERATION
Blowing
014607
Hold the blower firmly with a hand and perform the
blowing operation by moving it around slowly.
When blowing around a building, a big stone or a
vehicle, direct the nozzle away from them.
When performing an operation in corner, start from the
corner and then move to wide area.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Cleaning
014609
From time to time, wipe off the outside of the tool using
a cloth dampened in soapy water.
Replacing carbon brushes
001145
5
1. Limit mark
1
Publicidad
