Velleman WB018 Manual Del Usuario página 4

1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
• Check the contents prior to assembly. Use proper tools and never use defective or deformed
parts as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware
for mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
• Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman Components
nv. Respect all installation and operating directions of the device to be mounted/installed
(LCD/plasma display).
• Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
• Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LCD/plasma TV
• easy installation
• in accordance with VESA standard 50/75/100
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on pages 2Error! Bookmark not defined. and 3 of this manual.
1) Use the ceiling mounting bracket to determine and indicate the position of the mounting holes.
1a) When mounting on a brick or concrete ceiling, drill holes size Ø8mm and at least 60mm deep
at the indicated positions. Insert the included anchors [D] and mount the ceiling mounting
bracket on the ceiling using the 4 included screws [C].
1b) When mounting on a wooden ceiling or wall support, drill holes size Ø3mm and at least 60mm
deep at the indicated positions. Make sure all the holes are blind holes. Mount the ceiling
mounting bracket on the ceiling using the 4 included screws [C].
2) Attach the pole with the larger diameter to the ceiling mounting bracket, side opening closest
to the bracket. Use bolt [J] and nut [M] and 2 screws [K]. Slide the cover over the pole, line
up the rubber taps with the holes in the ceiling bracket and push the cover in place.
3) Slide the other pole into the fixed pole until the desired height is reached. Line up the holes
from the inner and outer pole and use bolt [J] and nut [M] together with screw [L] to
secure the inner pole. Close the bottom of the inner pole with cap [N] and the front with cap
[O].
4) Mount the TV mounting bracket on the back of the TV as indicated. Depending on the TV
screen, use the correct screws [A] or [B].
5) Hold the screen tight while attaching the TV mounting bracket to the inner pole. Use bolt [E]
and nut [F] together with the 2 washers [H] as indicated. Position the TV in the desired
horizontal angle and tighten the nut [F].
18/12/2008
WB018
User manual
4
© 2008 Velleman Components nv