Qlima DD 208 Instrucciones De Uso página 33

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROTECTION OF INTERNAL OVER HEATING
During operating, the abnormal or malfunction may happen due to air intake or exhaust
being obstructed or blocked which could occasionally resulting internal temperature
ascending, the unit will shut down automatically.
Unplug from power socket immediately and resume to operate after 5 minutes.
PROTECTION OF FALLING OVER
The unit has heater inside. In order to avoid over heating ,the machine is equipped with
tipping switch to automatically shut off when the machine fall down.
CLOTHES DRY (H SPEED) PERFORMANCE:
Press H mode to accelerate air flow which defining to dry your clothes. The optional air
blow direction can be set by pressing "Swing" to adjust angle of air guide from 45 degree
to 90 degree.
If you use this function ,please pay much attention; the water from clothes must not drip
down to the unit, which may destroy the unit or cause the risk of electric shock.
CONTINUOUS DRAINAGE
Ensure that unit unplugged from power supply. Remove water reservoir out and connect
a water drain hose to spigot (as shown on figures) The other end of this hose must be led
to a drain or a suitable receptacle to collect water.
Drain hoses must be installed at lower level compared with the drain hole (water spigot)or
water will flow back to the drain whole and flow to the water tank.
CLEANING FILTER
Manually remove air filter. Use a vacuum cleaner or wash in cool water to clean filter.
(As shown on figure)
Pull out the filter as shown
Must dry thoroughly before replacing filter in the unit
4
33
33

Publicidad

Tabla de contenido
loading

Tabla de contenido