Kohler K-26080-0 Instrucciones De Instalación página 6

3. Align the Bath
Drain
Pipe
NOTICE: Provide adequate floor support.
CAUTION: Risk of personal injury. This bath is heavy. Obtain sufficient help and use lifting straps to lift or move
the bath.
CAUTION: Risk of property damage. Verify that any factory-installed drain connections have not become loose
during shipping. Tighten as needed to prevent leakage.
Stack together two 6' (1.8 m) lengths of 2x4 lumber. Secure the stacked 2x4s together with nails or screws.
Position the stacked 2x4s on each side of the drain pipe to temporarily support the bath.
Ensure that the stacked 2x4s are positioned in a way that allows the adjustable feet to be accessed while the bath rests
on the 2x4s.
With help, use lifting straps to carefully lift the bath into position on the 2x4s so the bath drain is over the drain pipe.
Carefully reposition the bath as needed so the bath drain is directly over the drain pipe.
Turn the bath feet so that the bottom of each foot protrudes approximately 1/8" (3 mm) to 3/16" (5 mm) from the
underside of the bath.
IMPORTANT! The feet must extend past the bath shell and be level with each other so that the weight of the bath is
evenly supported by all four feet.
Use lifting straps and get additional assistance to remove the 2x4 supports and carefully set the bath on the floor.
1499221-2-A
Drain
Pipe
2x4s
6
Bath Drain
Kohler Co.