Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
3. Insert three plastic wall anchors
into the holes.
4. Attach the wall bracket with three ST4×35
screws to ensure installation is secure.
5. Before attaching the heater, make sure the
power switch is on the right side, in the OFF
position with unit unplugged, then install the
bracket and heater using the hex wrench and
two M6×14 bolts and wingnuts.
WARNING: To reduce the risk of fire, do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of the heater.
INCORRECT
OPERATING INSTRUCTIONS
1. Ensure the heater is properly installed before it is used.
2. Use ON/OFF switch on the right side of the unit.
3. Using the remote, POWER
mode. Power levels can only be controlled with the remote.
4. Press button for desired heat level: 500W-1000W-1500W.
5. When finished using the heater, press Red
OFF switch on the right side of the unit to turn off.
NOTE: Heater should only be facing area that will be heated. It should not be rotated
up to face the ceiling or downward to face the wall. Heater should only be wall
mounted and not in any other position
Page 8
INCORRECT
Button switches the heater on/off or on standby
button on remote, and then use ON/
CORRECT
Publicidad
