Gallagher SMART FENCE 2 Manual De Instrucciones página 6

Electrifying the Smart Fence 2
Joining two Smart Fence 2 units for longer fences
A) Place unit 1 in the
ground at a 90 degree
angle to the fence line.
Attaching the
Smart Fence 2 to a
permanent fence
Loop a guy rope around
the permanent fence post
and re-attach to the end
post/reel post.
* Leadsets not included. Packaged
with energizers or sold separately.
Maintenance
If a wire breakage occurs, tie the smallest knot possible.
Gallagher recommends tying a reef knot to feed through
the reel system.
If spare parts are required Gallagher provides a full range of SmartFence 2 replacement parts.
Contact your local Gallagher dealer or visit www.gallagher.co to find out more.
6.
From a
permanent fence:
Attach a leadset* from
the live permanent
fence wire to the metal
crimp on the end post.
B) Place the end post of
unit 2 into the first post
holder of unit 1.
From a
portable energizer:
Attach the green
leadset to the earth
stake and the red
leadset to the metal
crimp on the end
post.
C) Join wires by looping
the top wire of unit 2
around the main post of
unit 1 to create a contact.
NOTE: DO NOT STAND ON
LOWER POST HOLDER