Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2 - 3.
1. Machine
2. Battery
3. Battery unlock button
4. Work light
5. On / off switch
6. 3/8" (9.5 mm) square chuck
7. Direction switch
9. Lock lever
10. Battery LED indicators button
11. Battery LED indicators
12. Charger
13. Charger LED indicators
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the machi-
ne as shown in Fig. B.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (3).
2. Pull the battery out of the machine like shown
in Fig. B.
Checking the battery charging status (Fig. C)
• To check the battery charge status, push the
button (10) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
8
Charging the battery with the charger (Fig. C)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (12) as shown in Fig. C.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on the
charger (13) will lighten up and show the char-
ger status.
The charger has 2 LED indicators (13) which indi
cate the status of the charging process:
Red LED Status
Green LED status
Off
Off
Off
On
On
Off
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
When the machine is not being used over
a longer period of time it is best to store the
battery in charged condition.
Removing and mounting accessories
• Turn off the machine.
• Remove socket from chuck (6), if there is one.
• Click the new socket on the chuck (6).
• Check if the socket is properly attached.
• To remove the socket, simply pull it off.
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
WWW.VONROC.COM
Publicidad
