VONROC WL509AC Traducción Del Manual Original página 4

EN
1. SAFETY INSTRUCTIONS
Read the enclosed safety warnings, the additional
safety warnings and the instructions. Failure to
follow the safety warnings and the instructions may
result in electric shock, fi re and/or serious injury.
Save the safety warnings and the instructions for
future reference.
The following symbols are used in the user manual
or on the product:
Read the user manual.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-obser-
vance of the instructions in this manual.
Risk of electric shock.
Class II appliance.
Not suitable for applications with external
dimmers.
IP44 Protection class IP44.
Do not dispose of the product in unsuitable
containers.
The product is in accordance with the
applicable safety standards in the European
directives.
SAFETY WARNINGS FOR JOBSITE LIGHT
a) Please read and observe all safety warnings
and instructions enclosed with the jobsite light.
b) Do not use the jobsite light in hazardous areas.
c) Do not direct the light beam at persons or
animals and do not stare into the light yourself
(not even from a distance).
d) Do not cover the lamp while operating the
jobsite light. The jobsite light heats up during
operation.
e) Do not allow children to use the jobsite light.
It is intended for professional use. Children
can unintentionally blind themselves or other
persons.
4
2. MACHINE INFORMATION
Intended use
The 360° jobsite area light is intended as mobile
illumination for temporary use and is not suitable
for permanent room lighting.
TECHNICAL SPECIFICATIONS
Model No.
Input
Power
Luminous fl ux
Beam angle
Cable length
Ingress protection class
Height
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Carrying handle
2. Lamp
3. Locking screw
4. Tripod leg
5. Power switch
6. Power cord
3. OPERATION
Do not connect the jobsite light to external
dimmers of any kind. The jobsite light is not
suitable for use in combination with
external dimmers. Using an external
dimmer can cause irreparable damage to
the jobsite light and/or the dimmer circuit.
Only connect the jobsite light to a regular
220-240V~ 50Hz outlet.
Place the tripod stand (Fig. A, B)
1) Loosen the locking screw (3).
2) Fully extend the tripod legs (4).
3) Re-tighten the locking screw (3).
4) Place the jobsite light on a stable, level surface.
The tripod legs (4) must always be fully
extended to ensure the stability of the
tripod and prevent the jobsite light from
tipping over / falling.
WL509AC
220-240V~ 50/60Hz
76W
11500lm
360º
5m
IP44
145 cm
WWW.VONROC.COM