3M PG II Manual Del Propietário página 4

Important Safety Instructions
WARNING
CAUTION
NOTICE
SAFETY INSTRUCTIONS FOR ALL ELECTRIC HOT MELT APPLICATORS
WARNING
To reduce the risk of electrical shock or injury, observe the
following safety rules:
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
• Children or persons needing supervision should be supervised to
ensure they do not play with the appliance.
• WARNING: This tool must be placed on its stand when not in use.
• Operate and service the applicator only as described in this manual.
• Connect the applicator only to a properly grounded outlet.
• Do not unplug the applicator by pulling on the cord. Grasp the
plug, not the cord, to unplug.
• Do not handle the plug or applicator with wet hands.
• Do not use the applicator outdoors or on wet surfaces.
• Do not use the applicator if the cord or plug is damaged.
• Do not use the applicator if it is not working properly or has been
damaged, submerged in water or left outdoors.
4
Explanation of Signal Word Consequences
Indicates a hazardous situation which, if not avoided, could result in serious injury or death.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate
injury and/or property damage.
Indicates a situation which, if not avoided, could result in property damage.
WARNING
• Use only 3M-authorized replacement parts. Use of other
replacement parts may cause hazardous conditions or damage
the applicator. Repairs should only be performed by a qualified
repair person.
• If the supply cord is damaged, it must be replaced by a qualified
repair person or returned to 3M. Please contact your local 3M sales
representative for assistance.
• DO NOT USE NEAR HIGHLY FLAMMABLE MATERIALS.
• If an extension cord is used, use an extension cord that complies
with local electrical requirements and is properly rated for
your application. Use of an improper extension cord may cause
electrical shock.
• Do not clean or remove the 3M™ Hot Melt Adhesive with solvent.
May cause fire. For additional health and safety information see the
product label and Safety Data Sheet for Hot Melt Adhesive used.
• Do not modify the plug provided with the applicator or use
with an adaptor or ungrounded outlet. Improper grounding
connection of the applicator may cause electric shock. Check
with a qualified electrician or service person to determine
whether the plug is properly grounded. If the plug will not fit the
outlet, have a qualified electrician or service person install the
proper outlet.
© 3M 2020.