3M PG II Manual Del Propietário página 9

Preventive Maintenance
During Operation
Always use the bench stand provided when 3M™ Hot Melt
Applicator PG II is not in use. Do not lay the applicator on its side.
This impedes cooling process and may cause plugging problems.
After Operation
Before shutting down the 3M Hot Melt Applicator PG II put the
electrical switch in the "off" position. Continue using the applicator
until approximately one adhesive stick has been discharged. If
3M Hot Melt Applicator PG II has not been in use but still on heat
prior to shut down without extruding adhesive, allow at least one
hour for heat-up.
© 3M 2020.
Open adhesive cartridge stick only when necessary. Keep sticks
clean and free from airborne contaminants.
Lubricate inside loading chamber with 3M™ Silicone Lubricant or
equivalent once a week.
9