Alogic Clarity Guia De Inicio Rapido página 6

Unpacking and Assembly
Before unpacking the stand, ensure that the box is placed on a flat, clear surface.
1. Open the lid of the monitor box, remove the upper Styrofoam tray containing
the stand and place it to one side.
3. Carefully lift the monitor out of the Styrofoam tray and stand it on the desk ready for use.
Disassembly and Storage
Before disassembling the monitor, ensure that the box is placed on a flat, clear surface.
1. Open the lid of the monitor box, remove the upper Styrofoam tray and place it
to one side.
2. Place the soft bag over the monitor and lay it in face down in the Styrofoam
tray in the box. Ensure that the bag sits flat against the screen of the monitor
and is not folded over itself or bunched up. Excessive bunching of the bag
under the monitor screen may damage the screen when it is laid in the box.
3. Open the bag to reveal where the monitor attaches to the stand. Push the
monitor stand latch toward the top edge of the monitor and lift the base of the
stand upwards to release the stand from the monitor.
Push latch toward
top edge of monitor
6
Self-tightening screw
Push stand up
and lift away
from monitor
2. Open the soft bag that protects the monitor to reveal where the stand
attaches to the rear of the monitor. Leave the monitor laying in the Styrofoam
tray to avoid damaging it while installing the stand.
Insert the top of the monitor stand into the mount on the rear of the monitor
and press downwards on the stand until it clicks into place. Do not use
excessive force to ensure that the monitor is not damaged.
Warning: Do not put pressure on the display area of the
monitor while assembling or moving the monitor. The display
screen is fragile - applying force to it will break the display.
Keep the monitor box and Styrofoam packaging for future
transportation and storage of the monitor.
4. Close the bag and fold neatly over the rear of the monitor. Place the upper
Styrofoam tray on top of the monitor in the box.
5. Undo the screw, separating the base from the stand and place both pieces in
the upper foam packaging tray.
Stand Base
Thumb screw
Mounting bracket position
Accessory bag
Stand Stem