Alogic Clarity Guia De Inicio Rapido página 7

Mounting Options
The monitor has 75 x 75mm spaced mounting holes to allow it to be mounted to any compatible 75mm VESA standard monitor arm or wall mount accessory (not included).
The mounting holes are recessed in the region on the back of the monitor where the stand attaches and are hidden by the stand when it is installed. VESA mounts
cannot be used with the monitor while the stand is attached.
M4 threaded mounting spacers are included with the monitor which must be used when mounting the monitor to a monitor arm or other mount. Mount the monitor to a
VESA mounting accessory as follows.
1. Lay the monitor face down in its Styrofoam packaging tray.
Do not attempt to lay the screen on any uneven surface including soft
surfaces such as carpet and seating while attaching the mounting
accessory - damage to the screen may occur.
2. Locate the mounting spacers in the accessory bag that comes with the
monitor. With the monitor laying in its Styrofoam tray, screw in the four
spacers into the holes in the recess where the stand attaches. Do not over
tighten - tightening the spacers too much may cause damage to the monitor.
3. Screw the VESA mounting accessory into the mounting spacers.
Do not apply pressure to the rear of the monitor while fitting the mounting
accessory - downwards pressure on the screen may crack or otherwise
damage it.
Connecting the Monitor
Connecting the Power Cable
Connect the included power cable to the power connector, and then plug the other end into a wall outlet.
4. Carefully lift the monitor and mounting accessory out of the tray and place
into position.
Studs M4* X 4
Ensure there is 50mm clearance around all sides of the monitor when it is
installed to ensure that is does not overheat.
Adapter Power Cable
EN
7