Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
5
Installing the stopper and
horizontal rod
□
Before installation, unscrew the protective cap
(1) from the horizontal rod (P).
□
Insert the stopper (J) into the drain hole in the
sink.
□
Insert the horizontal rod (P) into the drain body
(N) and through the hole of the stopper (J). See
insert 2.
□
For easier removal and cleaning, rotate the
stopper (J) 90 degrees so that the horizontal
rod (P) does not go through the hole in the
stopper (J). See insert 3.
□
Make sure the joint (O) on the horizontal rod (P)
inserts into the drain body (N) completely, as
shown (4). You can press the two sides of the
joint (O) to remove the horizontal rod (P).
P
1
Insert 3
N
J
2
N
Insert 2
P
O
4
O
6
Attaching the horizontal rod
and strap
□
Slide the lift rod (S) through the faucet (A).
□
Press the rod (P) down to ensure the stopper (J)
is in the maximum open position.
□
Slide the clip (R) upward, adjust the location of
the lift rod strap (Q) to the appropriate height and
insert the horizontal rod (P) with the correct hole
of the lift rod strap (Q).
□
Move the lift rod strap (Q) in or out to choose an
appropriate location.
6
S
A
J
Q
R
3
2
R
P
4
4
Hole
J
Q
R
P
Publicidad
