Metra 99-7617HG Instrucciones De Instalación página 3

ISO DIN radio provision with pocket
1. Attach the pocket to the radio
brackets using the (4) #8 x 3/8"
Phillips screws provided. (Figure A)
2. If equipped with automatic climate
controls, secure the climate module
removed in Dash Disassembly,
to the radio brackets, using the
factory hardware. (Figure B)
3. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
4. Slide the radio into the bracket/
pocket assembly, and then secure
it using the screws supplied with
the radio. (Figure C)
5. Locate the factory wiring harness
and antenna connector in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
6. Reassemble the dash in reverse
order of disassembly.
99-7617HG
Kit Assembly
(Figure A)
®
(Figure B)
3
(Figure C)