4
www.electrolux.com
exhaust smoke and steam from other appliances (central heating
systems, thermosiphons, water-heaters, etc.).
• When the appliance operates with other appliances the maximum
vacuum generated in the room should not exceed 0.04 mbar.
• Make sure not to cause damage to the mains cable. Contact our
Authorised Service Centre or an electrician to change a damaged
mains cable.
• If the appliance is connected directly to the power supply, the electri-
cal installation must be equipped with an isolating device that allows
to disconnect the appliance from the mains at all poles. Complete
disconnection must comply with conditions specifi ed in the overvol-
tage category III. The means for disconnection must be incorporated
in the fi xed wiring in accordance with the wiring rules.
• Do not fl ambé under the appliance.
• Do not use to exhaust hazardous or explosive materials and vapours.
• Clean the appliance regularly to prevent the deterioration of the
surface material.
• Clean the appliance with a soft cloth regularly.
• Do not use a steam cleaner, water spray, harsh abrasive cleaners
or sharp metal scrapers to clean the surface of the appliance. Use
only neutral detergents.
• Clean grease fi lters regularly (at least every 2 months) and remove
grease deposits from the appliance to prevent the risk of fi re.
• Use a cloth or brush to clean the interior of the appliance.
2. SAFETY INSTRUCTIONS
2.1 Installation
WARNING!
Risk of injury, electric shock, fi re,
burns or damage to the appliance.
• Only a qualifi ed person must install this
appliance.
• Do not install or use a damaged appliance.
• Follow the installation instructions supplied
with the appliance.
• Always take care when moving the ap-
pliance as it is heavy. Always use safety
gloves and enclosed footwear.
• Before installing the appliance remove
all the packaging, the labelling and the
protective fi lm.
• Do not install the exhaust air into a wall
cavity, unless the cavity is designed for
that purpose.
2.2 Electrical connection
WARNING!
Risk of fi re and electric shock.
• All electrical connections should be made
by a qualifi ed electrician.
• Make sure that the parameters on the ra-
ting plate are compatible with the electrical
ratings of the mains power supply.
• If the symbol (
) is not printed on the ra-
ting plate, the appliance must be earthed.
• Always use a correctly installed hockproof
socket.
• Do not let the electricity mains cable
tangle.