Troubleshooting - Broil King Smoke Vertical Gas Manual Del Usuario

TROUBLESHOOTING

PROBLEM
SMELL OF GAS
Leak detected at any
connection.
Flames Beneath Control
Panel (Flashback Fire)
Burner Not Lighting
Ignitor Not Working
Decreasing Heat, "Popping
Sound"
Yellow Flame
Inside of Lid Appears to be
Peeling
Cooking Grids Rusting
If troubleshooting fails to solve any of these or any other issues, please visit www.omcbbq.com for more information
including troubleshooting videos, tricks and tips or call customer service at 1-800-265-2150
POSSIBLE CAUSE
SHUT OFF GAS SUPPLY AT ONCE.
DO NOT USE THE APPLIANCE UNTIL LEAK IS SEALED.
1. Quick disconnect coupling not seated fully.
2. Gas leak in connection.
3. Gas leak in hose or control valves
1. Venturi blocked.
1. Gas shut off valve closed.
2. Ignitor issue.
3. Venturi blocked or misaligned with valve
orifice.
4. Orifice(s) blocked.
5. Hose is twisted.
1. Ignitor battery is dead
2. Ignitor wire(s) not connected
3. Electrode misaligned on burner
4. Ignitor malfunction
1. Venturi blocked.
1. Some yellow flame is normal. If it is
excessive, the venturi may be blocked.
2. Burner ports blocked.
1. This is a build-up of grease. The inside of
lid is not painted and cannot peel.
1. Porcelain enamel has been chipped
CORRECTIVE ACTION
1. Remove and reconnect coupling
2. Tighten connection and "Leak Test".
3. See authorized service centre
1. Remove burner and clean venturi. See
"Venturi Tubes" (page 6)
1. Open gas shut off valve.
2. Try manually lighting burner with a match. See
"Lighting" (page 7). If burner lights
successfully, it is an ignitor issue. See "Ignitor
not Working" below
3. Remove burner, clean venturi and realign
with valve orifice. See page 6 for assistance.
4. Remove burner, clean orifices with a pin or fine
wire. Do not drill orifices.
5. Straighten hose. Keep away from bottom
casting.
1. Replace battery
2. Ensure main burner and side burner electrode
wires are all connected
3. Realign electrode and clear any surrounding
debris from area
4. Use "Match Lighting" procedure. (Page 7)
1. Remove burner, clean venturi. See "Venturi
Tubes" (Page 6) for assistance.
1. Remove burner, clean venturi. See "Venturi
Tubes" (page 6) for assistance.
2. Remove burner & clean with soft bristle brush
(e.g. toothbrush).
1. Clean with stiff bristle brush or scraper.
1. See "Maintenance" (page 10) for help
11