Electrical Connection; Switching Off; Troubleshooting - BOMANN WKS 1952 CB Instrucciones De Servicio

5. Electrical connection

• Check whether the electrical voltage that you intend to
use is the same as that of the machine. Details are to be
found on the label on the base.
• Only connect the machine to a properly installed 230 V,
50 Hz safety socket.
6. Switch on the kettle by pressing the switch. To control lamp
lights up.
7. When the water is boiling the kettle switches itself off
automatically unless you press the switch to interrupt or stop
the water from boiling.
WARNING: Danger of scalding!
• When pouring the water out, keep the lid closed.
• During operation the housing becomes hot. Do not
touch it and allow the device to cool down before storing it
away.

Switching off

• If you do not wish to use the kettle any more, please turn the
switch to 0 (off) and then remove the plug from the socket.
The control lamp goes off.
• Emptying the water container.
Mains Cable Take-up Device
The mains cable can be wound up on the base.
Cleaning
• Always pull out the plug from the mains socket before
cleaning and wait until the unit has cooled down.
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Never immerse the device or the base in water or other
liquids.
Water Container
• Rinse the water container out with clean water. Then dry it
off with a cloth.
Exterior of the Housing
• Clean the housing after use with a slightly damp cloth.
• There is a permanent fi lter in the spout. In order to clean the
fi lter, pull it out with the lid open. Rinse out the fi lter with run-
ning water. Reinsert it, taking note of the guide mechanism.
05-WKS 1952 CB Mephisto.indd 23 05-WKS 1952 CB Mephisto.indd 23
Decalcifi cation
• The frequency of the decalcifying operation depends on the
hardness of the water and on how often the appliance is
used.
• If the machine switches off before the water boils, it probably
needs to be decalcifi ed.
• Please do not use vinegar but a commercially available
decalcifi cation agent on the basis of citric acid. Only use the
quantities stated in the instructions.
NOTE:
After descaling the device boil fresh water in it several times
(approximately 3-4 times) in order to remove any residues. Do
not consume this water.

Troubleshooting

• It is not possible to switch the machine on.
Possible Cause:
After being used without or with too little water the machine
has not cooled down suffi ciently.
Remedy:
Allow the machine to cool down for 15 min.
• The machine switches off before the water has boiled.
Possible Cause:
The heated base is coated with too much lime or the circuit
of the plug is overloaded.
Remedy:
Descale the machine as instructed.
Check the mains connection.
• The machine does not switch off.
Possible Cause:
The lid is not closed.
Remedy:
Close the lid.
Data
Model: ..................................................................... WKS 1952 CB
Power supply: .....................................................220-240 V, 50 Hz
Power consumption: ..........................................................2200 W
Protection class: ........................................................................... Ι
Filling quantity: .........................................................max. 1.7 Litre
Net weight: ...........................................................................1.4 kg
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!
23
04.02.2008 9:20:07 Uhr 04.02.2008 9:20:07 Uhr