Hilti TE DRS-Y Manual Del Usuario página 19

Trouble or fault
An excessive amount of dust
is generated.
Dust module drops off
Dust module cannot be re-
moved.
Steady acoustic signal emit-
ted by the dust extractor.
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 Further information
For more information on operation,
qr.hilti.com/manual/?id=2494449
This link is also to be found at the end of the operating instructions, in the form of a QR code.
*2055779*
Possible cause
Dust extractor full.
Suction head and/or bellows gaiter
worn or faulty.
Suction channel clogged.
Exposed accessory tool length
more than 145 mm.
Suction hose of the dust extractor
not correctly installed.
Debris from the drilled core clog-
ging the extractor.
Distance between percussion core
bit and suction tube excessive.
Dust removal module not correctly
installed.
Base unit and/or tool neck oily or
greasy.
Auxiliary handle not tightened.
Auxiliary handle broken.
Adapter not installed.
Auxiliary handle clamping band not
sufficiently opened
Nubs on the bellows gaiter worn
off.
technology,
2055779
Action to be taken
▶ Empty the dust extractor.
▶ Replace suction head and/or
bellows gaiter.
▶ Clean the suction channel.
▶ Use a shorter accessory tool or
a longer suction head.
▶ Push suction hose of the dust
extractor fully into the base unit.
▶ Remove the drilled core and
drilling fines.
▶ Use only Hilti percussion core
bits.
▶ Install dust module in ac-
cordance with the operating
instructions. Base unit must
be installed in the intended
position.
▶ Use a cloth to wipe oil and
grease off the base unit and
the outside surfaces of the tool
neck.
▶ Tighten auxiliary handle.
▶ Replace auxiliary handle.
▶ Install adapter.
▶ Loosen auxiliary handle further
to open the clamping band
further.
▶ Replace bellows gaiter.
environment and recycling, follow this link:
English 13