GE AEQ10 Serie Manual Del Propietario E Instrucciones De Instalación página 4

About the controls on the air conditioner.
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
NOTE: The display always
shows the room temperature
except when setting the Set
temperature or the Delay timer.
Air Conditioner Controls
Controls
Power Pad
Turns air conditioner on and off. When turned
on, the display will show the room temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Set temperature
while setting the temperature in Cool or Energy
Saver modes. The Set light will turn on while
setting.
Temp Increase
Use to set temperature when in Cool or Energy
Saver mode. The Set light will turn on while
setting.
Delay Timer Increase
Pads
Each touch of the Increase
pads on the unit or the Increase
–
pads on the remote control will set the delay
time when using the Delay 1–24hr timer. The
Set light will turn on while setting.
Fan Speed Pads
Use to set the fan speed to Low, Med, High
or Auto on the unit. NOTE: On the remote
control, use the fan speed Increase
Decrease
Med or High. Use the Auto pad to turn Auto
fan on.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to
degree Celcius (°C), press the Temp Increase
seconds. Repeat the process to change back to degree Fahrenheit (°F)
4
Light indicates the unit
is in the temperature or
delay time Set mode.
Light indicates the
delay timer is set.
/Decrease
(+) /Decrease
/ Decrease
+
/ Decrease
–
pads to set the fan speeds to Low,
Delay 1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
set Increase
and Decrease
Mode Pad
Use to set the air conditioner to Cool, Energy
Saver or Fan Only mode.
Delay Pads/Delay 1-24hr Pad
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
it can be set to automatically turn off in 1 to
24 hours.
Pads
How to set:
Press the Delay 1–24hr pad on the unit or the
Delay pad on the remote control. Each touch
(–)
of the Increase
unit or the Increase
the remote control will set the timer in 1-hour
intervals. The Set light will turn on while setting.
To review the remaining time on the Delay
1–24hr timer, press the Delay 1–24hr pad on
the unit or the Delay pad on the remote control.
Use the Increase
unit or the Increase
remote control to set a new time if desired.
+
/
To cancel the timer, press the Delay 1–24hr pad
until the light on the Delay 1–24hr pad goes off.
and Temp Decrease
Fan Fan
Remote Control
When the air conditioner is off, it can
When the air conditioner is on,
/ Decrease pads on the
+
/ Decrease
/ Decrease
+
/ Decrease
buttons together and hold for 3
Delay timer Increase
Auto Fan on
Fan speed Increase
Unit power on/off
–
pads on
pads on the
–
pads on the