Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS.-
1.-
Take the unit out of its box and
make sure that all of the pieces are
there, Fig.1:
(29) Main body; (56) Main post; (5)
handlebar; (1) Electronic monitor; (18)
Saddle post; (51) Front stabiliser bar
with wheels; (33) Rear stabiliser bar
with adjustable feet; (15) Saddle;
pedals (25R) Right and (25L) Left;
(62) Bottle; (60) Bottle holder; (10)
Bracket cover; (34) screws M-8x70;
(31) Curved washer 8x25x1.5; (30)
Cap nut M-8; (12) Handlebar locking
knob; (64) Pedal assembly key; (65)
Allen key 5mm.
2.- FITTING THE STABILISER
BARS.-
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
Take the front stabiliser bar with
wheels (51) and place it at the front of
your unit, as shown in Fig.2, insert the
M-8x70 screws (34), fit the washers
(31) and the nuts (30).
Then take the rear stabiliser bar with
the adjustable blocks (33) and carry
out the same assembly operation as
with the front stabiliser bar, tighten up
all of the nuts (30) securely.
3.- ATTACHING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the
letter, fitting these incorrectly could
damage the screw thread on the
pedal or the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right pedal (25R) is marked with
the letter (R).This screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely Fig.3.
The left pedal (25L) is marked with the
letter (L).This screws onto the left-
hand crank, also marked with an (L),
in an anti-clockwise direction. Tighten
securely Fig.3.
4.- FITTING THE MAIN POST.-
Bring the main post (56) up to the
boss on the main body, Fig.4, and
connect
terminals
Fig.4A. Insert the tip of the cable
sheath (63) into the cable tension
control support (T), as shown in
Fig.4B, pull the sheath (63) up slightly
and insert it into the slot, see Fig.4D,
then fit the main mast onto the boss
on the main body, Fig.4, taking care
not to pinch the cables and make sure
that
the
tensioning
operates correctly.
Put
bolts
washers (31), Fig.4, making sure that
the handlebar is straight and then
tighten securely.
5.- FITTING THE HANDLEBAR.-
Loosen the handlebar bracket, line the
handlebar (5) up with the main post
(56), Fig.5, then fit the bracket cover
(10).and the handlebar locking knob
(12) and tighten, but make sure that
the handlebar is aligned correctly
before tightening the screws securely.
6.- ATTACHING THE SADDLE.-
Remove screws (17) and washers
(16) from the bottom of the saddle
(15).
11
(54)
and
control
(52),
along
with
(55)
(63)
their
Publicidad
