Publicidad
Idiomas disponibles
Idiomas disponibles
LED
Red and blue
NOTE
• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will
turn red after blinking in blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption.
• The maximum transmission distance of the main unit's wireless signal is about 10 m, but may vary depending on your operating environment.
If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all because the
wireless signal cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the wireless subwoofer. Keep the unit away from water and moisture.
• For optimal listening performance, make sure that the area around the wireless subwoofer and the Wireless Receiver Module (sold separately)
is clear of any obstructions.
Auto EQ
The Auto EQ technology of Samsung provides more natural and softer bass by calibrating low frequency detected via the mic on the subwoofer.
Low frequency usually occurs due to the size of the room and the location of the subwoofer.
• Ensure the subwoofer is placed at least 8 cm away from walls, furniture or other partitions.
• You must keep the room as quiet as possible while operating the Auto EQ tuning.
• Do not use any buttons until the Auto EQ tuning is complete.
• Auto EQ tuning takes about 2 minutes.
• During Auto EQ tuning, there is no sound from the Soundbar's main unit and rear speakers.
If you are using the function for the first time
1. Press the
(Sound Control) button until Auto EQ is selected.
2. Press the Up/Down buttons to select Tuning, and then press the
3. Tuning will start, and the progress appears in percentage.
‒ To cancel tuning, press the Up, Down, Left, Right or
‒ If the tuning is failed, LED blinks in red.
‒ If the tuning is successful, LED blinks in blue.
If you have done the tuning process
1. Press the
(Sound Control) button until Auto EQ is selected.
2. Press the Up/Down buttons to select Tuning, and then press the
3. Press the Up/Down buttons to select one of the following options.
‒ On: Turn on the previously tuned EQ settings.
‒ Off: Turn on the default EQ settings.
‒ Tuning: Start the tuning process again.
Connecting an SWA-9500S (Sold Separately) to your Soundbar
Expand to true wireless surround sound by connecting the Samsung Wireless Rear Speaker Kit (SWA-9500S, sold separately) to your Soundbar.
For detailed information on connections, see the Samsung Wireless Rear Speaker Kit manual.
Status
Description
Blinking
Malfunction
button, and then press the
See the contact information for the Samsung Service
Center in this manual.
button.
button to confirm.
button.
ENG - 15
Resolution
Publicidad
