LG WT17BSS6H Manual Del Propietário página 40

Symptoms
Washing machine
will not operate
Reason
Control panel has powered
off due to inactivity.
Washing machine is
unplugged.
Water supply is turned off.
Controls are not set properly.
Door is open.
Circuit breaker/fuse is
tripped/blown.
Control needs to be reset.
Start/Pause was not pressed
after a cycle was set.
Extremely low water
pressure.
Washing machine is too cold.
Washing machine is heating
the water or making steam.
Solution
• This is normal. Press the ENCENDIDO/
APAGADO button to turn the washing
machine on.
• Make sure cord is plugged securely into
a working outlet.
• Turn both hot and cold taps fully on.
• Make sure the cycle was set correctly,
close the door and press the INICIO/
PAUSA button.
• Close the door and make sure that
nothing is caught under the door
preventing it from closing completely.
• Check house circuit breakers/fuses.
Replace fuses or reset breaker. The
washing machine should be on a
dedicated branch circuit. The washing
machine will resume the cycle where it
stopped once power is restored.
• Press the ENCENDIDO/APAGADO
button, then reselect the desired cycle
and press the INICIO/PAUSA button.
• Press the ENCENDIDO/APAGADO
button then reselect the desired cycle
and press the INICIO/PAUSA button. The
washing machine will shut off if the
INICIO/PAUSA button is not pressed
within 60 minutes.
• Check another tap in the house to make
sure that household water pressure is
adequate.
• If the washing machine has been
exposed to temperatures below freezing
for an extended period of time, allow it to
warm up before pressing the
ENCENDIDO/APAGADO button.
• The washing machine drum may stop
operating temporarily during certain
cycles, while water is safely heated to a
set temperature.
EN
39