Fenton RP175DW Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the record player can be irreparably damaged. The product must
also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OPERATION
1. Switch the function mode to PH. Turn on the power switch on the back of the record player. The PH indicator will light
up.
2. Place a record on the turntable platter and select the desired speed (33/45/78RPM) according to the record.
NOTE: when playing a 45RPM record, use the included 45RPM adapter located inside the
accessories bag.
3. Remove the stylus protector. Open the tone-arm clip to release the tone-arm. Push the lift lever
backward to raise the tone-arm and gently move the tone-arm to the desired position over the
record. The turntable will begin to spin when the arm is moved toward the record. Push the lift
lever forward to lower the tone-arm slowly onto the desired position on the record to begin playing
the record.
Remark:- This switch turns auto stop on or off. When the automatic stop is enabled, the platform will start rotating as
soon as the tone arm is placed over the record and will stop rotating when it has reached the end of the record. Some
vinyl records stop before the end or do not stop when the end is reached. In this case set Auto-stop to OFF.
4.
Turn the Volume Control Knob to adjust the volume.
5.
Turn the Pitch Control Knob to fine tune the speed
AUX
1. Press mode button until the BT indicator lights up, this is AUX IN mode also.
2.
Connect your audio device, MP3 player, mobile phones etc. to the AUX IN port with a 3.5mm jack audio cable (not
included). You can enjoy the music from the speaker of turntable player immediately.
3.
Turn the volume control knob to adjust the volume.
BT
1. Switch the function mode to BT. The LED indicator will become blue colour with flashing.
2. Turn on the BT function of your mobile phone, tablet or other BT device and search the turntable player with its name
Fenton recordplayer.
3.
After pairing and connection, the LED indicator will become blue colour without flashing and you can play your music
from your BT-device.
4. Turn the volume control knob to adjust the volume.
Remark: During the BT mode, please make sure that the AUX IN jack is not plugged.
Noted: This device does not have a BT transmitter, this means that it is not possible to send sound via BT to, for example, a BT
speaker
When the unit is used as a BT speaker, ALL OTHER PLAYBACK functionS cannot be used at the same time.
RECORD
Plug in the USB drive, press mode key to select phono, press and hold the
the recording from vinyl records to USB starts. Press and hold the
button until the USB/REC indicator flashes and
button to stop the recording.
4