Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
You can install by yourself your range based on the instructions described in this
manual.
Unpacking
01. Bring the appliance close to the
installation place.
02. Be careful when unpacking and
installing the appliance. Sharp
edges might cause accidents.
03. Packing material is recyclable.
Separate plastics, from cartoons and
foams to send to each recycling
company.
Installation place conditions
01. The use of the gas ranges produce
heat and humidity where are
installed.
02. Be sure that there is a good air flow,
keeping natural air ventilation
through a window or door or by
installing a range hood to extract the
air. If ventilation is not good, this
might cause lack of oxygen, what is
dangerous for your health and the
gas range performance.
03. If the gas range will be working for
a long period of time, an extra
ventilation will be necessary to
increase the air flow.
04. Air draft should not decrease the
good performance of the gas range
or cut the gas flame.
05. To install your gas range to a LPG
pipe, check if your house has a gas
Installation
37
Attention
If replacement of components
and/or accessories is necessary,
use original spare parts only.
tap exclusive for the gas range and
it this is in good condition.
06. Be sure that your house has an
exclusive plug for your gas range
and this is in good conditions.
07 Do not install the range on top of
carpets.
08. Do not install the range near the
refrigerator, as the excessive heat
hinders its yield. For any doubt see
the refrigerator´s manual.
09. If the gas supply will be through a
gas cylinder, and the cylinder is
more than 80 cm from the gas
range, the installation should use
steel and copper pipes according
to your local requirements.
Gas range installation
01. Never use the oven handle to pick
the oven up.
02. After unpacking the gas range,
take out the protector plastic that
protects the stainless steel cook top.
Do not use the gas range with this
protector plastic on it because it
might damage the stainless steel.
Heat will melt the plastic and make
it harder to take it out.
03. Install the burners and pan grill in
its place on the cook top of the gas
range.
04. Leave at least 2cm in the back and
each side of the gas range to allow
the heat to get out.
Installation
38
Publicidad
