Publicidad
Idiomas disponibles
Idiomas disponibles
05. Leave at least 80 to 85 cm between
the top of the gas range and any
cabinet or range hood install above
the product. This gas range is not
prepared to be installed built in.
06. Leave enought room between the
back of the oven and the wall, to
allow for opening the cover.
07. If the oven is installed next to a
wooden wall, please place a fire-
resistant panel next to the wall and
ensure that the oven is more than 4
cm from the wall. Please place 1pc
fire-resistant panel (lenght and a
high degree are more than 4 cm
than the oven ) between the wall
and the oven, if the oven will be
installed on wooden wall.
08. Make sure not to block the oven
gas exit, including the funnel or the
gas vents, when you install the
oven.
Backsplash assembling (only in some
models)
Backsplash is packed inside the oven
cavity. Unpack the backsplash and stand
it on assembled position. Fix backsplash
with 3 screws on each side as image
shows.
Installation
39
80 to 85 cm
2 cm
Attention
The guarantee does not cover the
problems caused by defective
installations or changes that were
performed by non-qualified
personnel.
Electric installation
For your safety, check the electric conditions of the place where the gas range
will be installed by a qualify electrician or contact an authorize service.
01. Before turning on the range, check
to see if the voltage of the outlet to
be used is the same as that
indicated on the tag located close
to the plug (along the power cord)
or on the gas range identification
label.
02. Install the ground cable or your
gas range according to your local
requirements.
03. If you need to modify the electric
installation, this should be
performed by qualified personnel.
04. Be sure that electric plug is easy to
reach after installation.
05. Power cord should never be in
contact with hot parts of the gas
range, because the plastic
protection might melt causing a
short circuit.
06. Connect the range to its own
outlet. Do not use an extension
cord or adaptor plug.
07. Never ground the appliance on
PVC or gas pipes.
08. Be sure that the power cord does
not goes through the back of the
gas range.
Attention
If you have any doubt, please
contact a qualified person.
Do not modify your gas range
plug.
Do not bite, twist or tie the
power cord.
It is dangerous to modify the
range specifications or
features.
Installation
40
Publicidad
