Publicidad
Idiomas disponibles
Idiomas disponibles
8
USE
8.1 INTRODUCTION
The board automatically controls the various operating parameters of the stove. The user can control the stove
manually, to switch it on or switch it off, or use the advanced functions such as the weekly programmer or the
timer.
8.2 FIRST START-UP
Once the board is powered, the LCD display will show the software version and then the stove status which, in
the case of first ignition, will be off.
For the best performance with the lowest consumption, follow these instructions.
•
The pellets will ignite very easily if it has been installed correctly and the flue is efficient.
•
Switch on the stove to Power 1, for at least 2 hours, to allow the materials from which the boiler and the fire box
are made to settle the internal elastic stresses.
•
When the stove is used, the paint inside the combustion chamber may undergo alterations. This phenomenon can
be attributable to various reasons: overheating of the stove, chemicals found in low quality pellets, bad chimney
draught, etc. Therefore, the preservation of the paint in the combustion chamber cannot be guaranteed.
•
During the first hours of operation, greasy processing residues and paints may produce odours and smoke: it is
recommended to ventilate the room because they can be harmful to people and animals.
•
The programming values from 1 to 5 are preset by the company and can be modified by an authorised technician
only.
8.3
THE STOVE PANEL
4
5
1) S ET:
Used to enter the menu and confirm data changes during the setting phase.
2) AUTO:
Allows you to switch stove operation from Automatic to Manual.
3) O N/OFF: To switch the stove On and Off. If there is an error, press it for a few seconds to reset the alarm.
Also used to exit the menu without changing data.
4) TEMP+:
Key to increase the desired temperature. Also used to scroll through the menus and data.
5) TEMP-:
Key to decrease the desired temperature. Also used to scroll through the menus and data.
6) PROG+:
Key to increase the desired operating power or program. Also used to scroll through the menus and data.
7) PROG-:
Key to decrease the desired operating power or program. Also used to scroll through the menus and data.
SET
AUTO
MAN
1
2
08/2021 - EN
6
7
3
17
Publicidad
