Publicidad
Idiomas disponibles
Idiomas disponibles
Underneath existing work top
(when fitting beneath a work top)
In most modern fitted kitchens there is only one
single work top under which cabinets and
electrical appliances are fitted. In this case remove
the work top of the dishwasher by unscrewing the
screws under the rear edge of the top (a).
Attention
After removing the work top, the screws MUST BE screwed again under the rear edge
of the top (b).
The height will then be reduced to 815 mm, as scheduled by the International
Regulations (ISO) and the dishwasher will fit perfectly under the kitchen working top
Built-In Installation
Step 1. Selecting the best location for the dishwasher
The installation position of dishwasher should be near the existing inlet and drain hoses
and power cord.
Illustrations of cabinet dimensions and installation position of the dishwasher.
1. Less than 5 mm between the top of dishwasher and cabinet and the outer door
aligned to cabinet.
(for the integrated model)
90 °
Electrical, drain
Electrical, drain
820mm
820mm
and water supply
and water supply
line entrances
line entrances
580mm
580mm
Space between cabinet
Space between cabinet
bottom and floor
bottom and floor
for 60cm model
600 mm(
mm
for 45cm model
450
(
21
90 °
80
80
100
100
)
)
a
a
b
b
Publicidad
