Descargar Imprimir esta página

Front Runner FALD008 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

RACK FITMENT ON VEHICLE WITH OEM RAILS
2
2.1
2.2
2.3
FALD008_REV_A02
9
8
7
6
14
13
12
11
T45
10mm
13mm
10
6
17
10mm
13mm
18
19
3
Remove the OEM rails from left and right
side of the vehicle.
Remove the front saddle bracket under both
rails.
Take your time and loosen with care.
The factory bolts are secured with high
strength thread locker, if rushed the roof
insert can break free.
Assemble the Front and Rear Foot Rails
(Items 1 & 2) using the Joiner Plate (Item
9) and M6 x 12 Button Head Bots, M6 x 12 x
1SS Flat Washers and M6 Nyloc Nuts (Items
7, 8 & 10) as shown.
Finish off by placing M6 Nut Caps (Item 6)
on the Nyloc Nuts.
Remove tape covering rear hole.
Place the Front and Rear Spacers as shown
into the ditch where you removed the OEM
rails.
Align the holes in the spacers with the
factory holes in the vehicles ditch.
Place a bead of all perpose/waterproof
silicone on the bolt threads before securing
to the roof.
Secure the Foot Rails to the vehicle using
M8 x 35 Hex Bolts, M8 SS Spring Washers
and M8 x 16 x 1.6SS Flat Washers (Items
11, 12 & 13) in all holes exept the one at the
rear.
Use an M6 x 35 Hex Bolts, M6 SS Spring
Washers and M6 x 19 x 1SS Flat Washers
(Items 17, 18 & 19) on the two rear holes in
the Foot Rail.
Fully tighten all bolts.
Finish off by placing M8 Nut Caps (Item 14)
on the M8 Bolt Heads and M6 Nut Caps (Item
6) on the M6 Bolt Heads.
© 2020 FRONT RUNNER VEHICLE OUTFITTERS

Publicidad

loading