RACK FITMENT ON VEHICLE WITHOUT OEM RAILS
4
4.1
4.2
4.3
FALD008_REV _A02
9
8
7
6
14
13
12
11
5
T30
10mm
13mm
10
6
17
10mm
13mm
18
19
5
Remove the plugs on the ditch cover.
Remove the screws under the plugs.
Assemble the Front and Rear Foot Rails
(Items 1 & 2) using the Joiner Plate (Item
9) and M6 x 12 Button Head Bots, M6 x 12 x
1SS Flat Washers and M6 Nyloc Nuts (Items
7, 8 & 10) as shown.
Finish off by placing M6 Nut Caps (Item 6)
on the Nyloc Nuts.
Place one Spacer (Item 5) into each of the
openings where the rail plugs was removed
in 2.1.
Place a bead of all-perpose/waterproof
silicone on the bolt threads before securing
to the roof.
Secure the Foot Rails to the vehicle using
M8 x 35 Hex Bolts, M8 SS Spring Washers
and M8 x 16 x 1.6SS Flat Washers (Items
11, 12 & 13) in all holes exept the one at the
rear.
Use an M6 x 35 Hex Bolts, M6 SS Spring
Washers and M6 x 19 x 1SS Flat Washers
(Items 17, 18 & 19) on the two rear holes in
the Foot Rail.
Fully tighten all bolts.
Finish off by placing M8 Nut Caps (Item 14)
on the M8 Bolt Heads and M6 Nut Caps (Item
6) on the M6 Bolt Heads.
© 2020 FRONT RUNNER VEHICLE OUTFITTERS