Front Runner FALD007 Manual De Instrucciones página 10

3 RACK ASSEMBLY - STANDARD SLATS
3.4
4 RACK ASSEMBLY- CORNERS
4.1
6
RRSTUNI_REV_A05
10
4MM
5
Square the Side Profiles and Slats up before
fully tightening all the fasteners.
Using a tape measure, measure from the one
corner across to the other corner. Do the
same on the opposite corners, if the two
measurement are the same the rack will be
square.
Fully tighten all the M8 x 25 Button Head Bolts.
The recommended torque setting for the
M8 Button Head Bolts is 20 Nm or
15 ft lb.
Flip the tray right side up.
Push the Corner into position as shown,
aligning the hole in the Corner with the
Rivnut already inserted in the Combined Slat.
Use a M6 x 12 Button Head Bolt (Item 10)
and fasten the Corner in position.
© 2019 FRONT RUNNER VEHICLE OUTFITTERS