Front Runner FALD007 Manual De Instrucciones página 3

2 FIT AND SECURE
2.1
2.2
2.3
FALD007_REV_A01
Before starting the fitment you need to
remove the front, middle and rear Ditch
Covers from the vehicle's roof.
Loosen the bolts holding the rail in place.
Do this on both sides of the vehicle.
T60
Place Spacers (Item 10) over each of the
holes where you have removed the bolts.
Secure the Front Foot Rail (Item 1) to the
vehicle using M8 x 60 Hex Bolts, M8 SS
Spring Washers and M8 x 25 x 2 Flat
Washers (Items 4, 5 & 6) as shown.
13mm
Finish of by placing M8 Nut Caps (Item 3)
on the bolt heads.
Repeat this on both sides of the vehicle.
Secure the Rear Foot Rail (Item 2) to the
vehicle using M8 x 70 Hex Bolts, M8 SS
Spring Washers and M8 x 25 x 2 Flat
Washers (Items 11, 5 & 6) as shown.
Finish of by placing M8 Nut Caps (Item 3)
on the bolt heads.
13mm
Repeat this on both sides of the vehicle.
3 © COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS
13mm