AQUA SPHERE VSP Serie Manual De Instrucciones página 11

Remark:
The pump is delivered with self-priming enabled. Each time the pump restarts, it will perform
self-priming automatically. The user can enter the parameter setting to disable the default
self-priming function (see 5.7)
If the default self-priming function is disabled, and the pump has not been used for a long
time, the water level in basket may drop, the user could manually activate the Boost mode of
priming to fill it (see 5.7), the adjustable period is from 600s to 1500s (default value is 600s).
for more than 3 seconds to exit the Boost mode.
The user could press
5.4 Backwash
User can start the backwash or fast re-circulation in any running state by pressing
Default
Time 180s
Running capacity 100%
If backwash is completed or disabled, press and hold
to the normal operating state before backwash.
5.5 Setting the running capacity
1
Press
2
Press
5.6 Timer mode
The pump's on/off and running capacity could be commanded by timer, which could be pro-
grammed daily as needed.
1
Enter timer setting by pressing
2
Press or to set the local time
3
Press to confirm and move to time 1 setting
4
Press or to choose the desired running periods and specific capacity or flow
5
Repeat above steps to set other 3 timers
6
Hold 3 seconds to save setting
7
or Check 4 timers to make sure there is no invalid setting
Note: Overlap setting of time will be considered as invalid, the pump will only run based on
the previous valid setting.
During timer setting, if you want to return to the previous setting, hold both
seconds.
Setting range
Press or to adjust from 0 to 1500s with 30 seconds for
each step
80~100%, enter the parameter setting (see 5.7)
for more than 3 seconds to unlock the screen, press
or to set the running capacity between 30%~100%, each step by 5%
11
for 3 seconds, the pump will return
to start
.
for 3