AQUA SPHERE VSP Serie Manual De Instrucciones página 12

5.7 Parameter Setting
Restore factory setting Under off mode, hold both
Check the software
version
Boost mode of priming
Enter parameter set-
ting as below
Parameter
Description
Address
1
2
3
4 Backwash capacity
Control mode of
5
Analog Input
Enable or disable the
6 priming that occurs
at each start
Under off mode, hold both
Under on mode hold both
Under off mode, hold both
need to be adjusted, hold both
Default Setting
PIN3 100%
PIN2 80%
PIN1 40%
100%
for 3 seconds
for 3 seconds
for 3 seconds
for 3 seconds; If current address does no
to next address.
30-100%, by 5% increments
30-100%, by 5% increments
30-100%, by 5% increments
80-100%, by 5% increments
0 0: current control
25 25:enables / 0: disables
12
Setting Range
1: Voltage control