AQUA SPHERE VSP Serie Manual De Instrucciones página 4

1. IMPORTANT SAFETY INSTRUCTIONS
WARNING:
This manual can be read and downloaded as a PDF file from the website: www.aquasphere-
manuals.com
• The appliance described in this manual is specially designed for the pre-filtering and recircu-
lation of water in swimming pools, with clean water at temperatures that do not exceed 35ºC
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
• This appliance can be used by children aged from 8 years and above and persons with re-
duced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children must not play with this appliance. Cleaning and
maintenance must not be carried out by children without supervision.
• Our pumps may only be assembled and installed in pools compliant with standards IEC/HD
60364-7-702 and required national rules. The installation should follow standard IEC/HD
60364-7-702 and required national rules for swimming pools. Consult your local dealer for
more information.
• If a self-priming pump is to be fitted above the water level, the pressure differential to the
pump suction pipe should not be higher than 0.015 MPa (1.5 mH2O). Ensure that the suction
pipe is as short as possible as a longer pipe would increase suction time and the installation's
load losses.
• The pump is intended to be used while fastened to a support or while secured in a specific
location in a horizontal position.
• Place a sump with an adequate outlet for the liquid where flooding is likely to occur.
• The pump cannot be installed in Zone 0 (Z0) or Zone 1 (Z1). To see drawings, refer to page 4/5.
• See the maximum total head (H max), in meters see page 3.
• The unit should be connected to an alternating current supply (see data on the pump’s
plate) with an earth connection, protected by a residual current device (RCD) with a rated re-
sidual operating current that does not exceed 30 mA.
• A disconnector must be fitted to the fixed electrical installation in accordance to the instal-
lation regulations.
• Failure to heed the warnings can cause serious damage to the pool's equipment or serious
injury, including death.
• Observe the regulations in force on accident prevention.
• Before handling the unit, ensure that the power supply is switched off and disconnected
from the mains.
• If the unit breaks down, do not try to repair it yourself. Contact a qualified service engineer
instead.
• All modifications to the pump require the manufacturer's prior authorization. Spare parts
and original accessories authorized by the manufacturer ensure greater safety. The pump's
manufacturer may not be held liable for any damage caused by unauthorized spare parts or
accessories.
4